2400W Wet & Dry Vacuum
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL No.:
MWW706S-35L-1200WC • 06/2018 • 61406
(toll free)
AFTER SALES SUPPORT
(toll free)
2400W Wet & Dry Vacuum
e-mail: [email protected]
1800 909 909
MODEL No.:
MWW706S-35L-1200WC • 06/2018 • 61406
22
23
Operation
Maintenance
This should ensure the locking pin on the flexible hose (17) aligns with the
ridge in the flexible hose outlet – blowing (8). Rotate the flexible hose (17)
to the left to secure the hose into position (Fig AF)
3. Select and attach additional extension tubes if required (Refer page 16).
4. Before turning ON, ensure you are firmly holding the end of the flexible
hose (17), or extension tube/s (18) if added (Fig AF).
5. Press the “I” on the
ON/OFF Switch (3)
to turn ON (Fig AG).
To turn OFF, press the
“O” on the ON/OFF
switch (Fig AH).
AH.
AG.
Cleaning
WARNING! You must pull out the power plug from the mains outlet
before commencing any cleaning, maintenance or inspection work
procedures on the appliance.
• Keep all safety devices, air vents and the motor housing and appliance
head (2) free of dirt and dust.
• We recommend that you clean and dry the appliance immediately after
each use.
Cleaning the Appliance Head
• Clean the appliance head (2) regularly with a damp cloth and some soap
followed by wiping down and drying before storing away.
• Do not submerse the appliance head (2) in water or allow water to enter
the appliance head (2).
• Do not use cleaning agents or solvents. These may be aggressive to the
plastic parts on the appliance.
Cleaning the Tank
• The tank (10) can be cleaned with a damp cloth and soap or rinsed under
running water depending on the amount of dirt. Wipe down and dry
before storing away.
Cleaning the HEPA Filter
• Clean the HEPA filter (16) regularly by carefully patting it and cleaning it
with a fine brush or hand brush (not supplied).
• Do not submerse the HEPA filter in water. Do not use a damp cloth to
clean.
Cleaning the Foam Filter
• Clean the foam filter (19) with a little soap under running water.
• Allow the foam filter (19) to completely air-dry before reinstalling or
storing away. Do not wring dry.
Check the Floating Safety Valve
• Check the floating safety valve (15) often to ensure it moves freely within
the filter basket (14). To do this, take the appliance head (2) by the handle
and tip it carefully so that the filter basket (14) is facing upwards. The
floating safety valve (15) should move freely up and down.
General Maintenance
• Before each use, inspect the general condition of the appliance and check
for the following:
• Loose hardware or screws.
• Misalignment or binding of moving parts.
• Damaged or electrical wiring.
• Check filters are securely fitted.
• Damaged or cracked tank.
• Any other condition that may affect safe operation
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
Maintenance
