Worksaver SSGB-8B, Руководство владельца/оператора

Страница: 20 / 36

18
STORAGE
——————————————————
• At the end of the working season or when the Grader
Blade will not be used for a long period, it is good
practice to clean off any dirt or grease that may have
accumulated.
• Inspect the Grader Blade for loose, damaged or worn
parts and adjust or replace if needed.
• Always store in a clean, dry location away from
children and livestock.
• Storage location should be level and solid to make
hitching and unhitching easy.
• Grease the unit.
• Check and adjust the tire pressure.
• Place plastic caps on the hydraulic hose ends.
• Check all bolts, nuts, screws and tighten.
• Touch up all areas where paint has been removed.
• Cover the unit to keep it clean.
• Coat hydraulic cylinder rods with lithium based grease.
GRADER LUBRICATION
——————————————————
Thoroughly clean the grease zerks before servicing. Dirt
mixed with lubricant will rapidly wear parts. Keep it clean.
Use a lithium grease of No. 2 consistency with a MOLY
(molybdenum disulfide) additive for all locations.
Lubricate the following points:
1. Blade Pivot Spindle
2. Caster Pivot Spindles
3. Front Axle Pivot
4. Torsion Beam Pivot (Vertical)
5. Torsion Beam Pivot (Tilt)
6. Caster Wheel Hubs
CHECK TIRE PRESSURE
——————————————————
Adjust the tire pressure for all tires to 50 psi (346
KN/m 2 ). Keep tire valves capped.
CHECK HYDRAULIC LINES
——————————————————
Check the hydraulic lines every 100 operating hours.
Inspect hoses for wear, cracks, loose connections,
leaks, etc. Repair hoses as needed.
IMPORTANT: Moving hydraulic hoses should be
replaced every two years or as wear dictates.
SERVICE INSTRUCTIONS
(continued)
GREASE LOCATIONS