Worksaver SSGB-8B, Руководство владельца/оператора

Страница: 16 / 36

14
GRADER INSTALLATION /
REMOVAL
(continued)
——————————————————
13. Mount grader control panel to skid steer with hard-
ware provided.
14. Connect black battery wire from grader to skid steer
negative battery terminal. Connect red wire to skid
steer positive battery terminal.
15. Test grader for proper hydraulic flow. Change position
of auxiliary hydraulic control on skid steer if grader
does not respond. (See skid steer operation manual).
NOTE: Grader has a check valve so hydraulic oil can only
flow correctly.
To Remove Grader From Skid Steer:
1. Turn off skid steer and make sure auxiliary hydraulic
controls are off (see skid steer manual).
2. Disconnect battery wires from battery terminals, start-
ing with the negative wire. Disconnect grader control
panel box wiring.
3. Disconnect auxiliary hydraulic hoses. Cap all hoses.
4. Unlatch skid steer attachment pins from grader mount-
ing plate.
5. Lower skid steer attachment mounting plate to the
ground.
6. Tilt skid steer attachment mounting plate forward and
back skid steer away from grader.
GRADER BLADE CONTROL PANEL
——————————————————
The grader blade control panel is intended to mount
vertically inside the skid steer for easy accessibility on the
operator’s left side.
The Grader has four control switches:
Grader Blade Rotation Switch (1)
Press the rotation switch
OHIW
to rotate the grader
blade
FRXQWHU
clockwise. Press the rotation switch
ULJKW
to rotate the grader blade clockwise.
Laser Power Switch (2)
If unit is equipped with laser, press the laser power switch
OHIW
to turn on. Press the laser power switch
ULJKW
to turn
off.
Right-Side Lift Switch ( )
Press the right-hand lift switch up to raise the right side of
the grader blade. Press the right-hand lift switch down to
lower the right side of the grader blade.
Left-Side Lift Switch ( )
Press the left-hand lift switch up to raise the left side of
the grader blade. Press the left-hand lift switch down to
lower the left side of the grader blade.
INSTRUCTIONS
(continued)
DANGER!
Escaping hydraulic fluid under pressure can pene-
trate the skin, causing serious injury.
DO NOT use your hand to check for leaks. Use a
piece of cardboard or paper to search for leaks.
Stop engine and relieve pressure before connecting
or disconnecting lines.
Tighten all connections before starting engine or
pressurizing lines.
If any fluid is injected into the skin, obtain medical
attention immediately, or gangrene may result.
10. Attach the grader hydraulic hose with the female con-
nector to the skid steer auxiliary hydraulic hose with
male connector.
IMPORTANT: Make sure connectors are clean prior to
installation.
11. Attach the grader hydraulic hose with the male con-
nector to the skid steer auxiliary hydraulic hose with
the female connector.
12. Route the hose to avoid pinching or chafing the hose.
Use nylon ties or tape to fasten hose on loader arm
to keep it in place. Make sure the hose routing and
length is adequate for your particular make and
model skid loader.