Worksaver SSGB-8B, Руководство владельца/оператора

Страница: 19 / 36

17
OWNER SERVICE
Check hydraulic hoses and fittings for leaks. Repair any
leaks immediately. Never use your hand to check for a
hydraulic leak when system is under pressure.
Thoroughly clean the grease zerks before servicing.
Dirt mixed with lubricant will rapidly wear parts. Keep it
clean.
Periodically check all bolts to make sure they are tight.
Check hydraulic hoses. Make sure they are not chafed
or pinched. Replace any damaged hose.
Replace any worn or damaged parts immediately. Do
not use attachment with any damaged parts.
Replace safety signs and instruction decals if damaged
or missing.
Replacing Cutting Edge
The grader blade uses a 1 /
2
” x 6” (12.7 x 152 mm)
cutting edge. It is reversible.
1. Raise the blade.
2. Place a 4” x 4” block under the lower moldboard sup-
port. Then lower the blade so the lower moldboard
support rests securely on the block.
3. Place two smaller blocks under the cutting edge so
when the cutting edge is loose from the blade it
doesn’t fall directly on the ground (these blocks will
also support the cutting edge when bolting it back on
the blade).
NOTE: Do not block the machine any higher than
necessary to remove cutting edge.
4. Refer to the Parts Drawings/Schematics on pages 21
and 22 for proper parts identification. Remove the hex
nuts and plow bolts that are securing the cutting edge
to the moldboard. Turn the cutting edge over and use
the new edge, or replace it if both edges have been
used.
5. Attach the cutting edge to the blade and secure with
plow bolts and hex nuts previously removed.
6. Torque plow bolts to specifications given in Bolt Torque
Chart, page 30.
MAINTENANCE
——————————————————
The information in this section is written for operators
who possess basic mechanical skills. If you need help,
your dealer has trained service technicians available. For
your protection, read and follow the safety information in
this manual.
WARNING!
Keep all persons away from operator control area
while performing adjustments, service, or mainte-
nance.
Before dismounting power unit or performing any
service or maintenance, follow these steps: disen-
gage power to equipment, lower all raised compo-
nents to the ground, operate valve levers to release
any hydraulic pressure, set parking brake, stop
engine, remove key, and unfasten seat belt. Never
leave equipment unattended with engine running.
WARNING!
NEVER GO UNDERNEATH EQUIPMENT. Never
place any part of the body underneath equipment or
between moveable parts even when the engine has
been turned off. Hydraulic system leak down,
hydraulic system failures, mechanical failures, or
movement of control levers can cause equipment to
drop or rotate unexpectedly and cause severe injury
or death.
• Read Manual for service instructions or have
service performed by a qualified dealer.