Woodstock SHOP FOX M1012, Инструкция по эксплуатации

Страница: 13 / 36

-11-
M1012 48" Pan and Box Brake
SE
TU
P
The unpainted surfaces are coated with a waxy oil to
protect them from corrosion during shipment. Remove
this protective coating with a solvent cleaner or citrus-
based degreaser or with liberal amounts of WD-40
®
.
DO NOT use chlorine-based solvents such as brake parts
cleaner or acetone—if you happen to splash some onto a
painted surface, you will ruin the finish.
Remove and thoroughly clean each finger block assem-
bly. Do this by first raising the clamping leaf to make
sure there is no pressure on the finger blocks; then, for
each finger block, remove the top cap screw shown in
Figure 6
and slide the entire finger block assembly off
of the front guide (
Figure 7
). This procedure is easiest if
you begin with a finger block on the end.
After the finger block assemblies have been cleaned,
coat them liberally with a metal protectant and rein-
stall. Make sure to follow the instructions on Page 16 to
re-align the fingers before operating your brake!
Cleaning Machine
Figure 7. Removed finger block assembly
shown for identification.
ALWAYS work in well-ventilated areas
far from possible ignition sources when
using solvents to clean machinery. Many
solvents are toxic when inhaled or
ingested. Use care when disposing of
waste rags and towels to be sure they DO
NOT create fire or environmental hazards.
NEVER use gasoline or other petroleum-
based solvents to clean with. Most have
low flash points, which make them
extremely flammable. A risk of explosion
and burning exists if these products are
used. Serious personal injury may occur
if this warning is ignored!
Figure 6.
Top cap screw for loosening
finger block to slide off front guide.
Removed Finger
Block Assembly
Top Cap Screw
Front Guide