Woodstock SHOP FOX M1012, Инструкция по эксплуатации

Страница: 17 / 36

-15-
M1012 48" Pan and Box Brake
O
PE
R
AT
IO
N
S
Although not required, we recommend that you mount
your new pan and box brake to the floor.
To ensure accurate operation results, make sure your
mounting location is as level as possible and that you
provide adequate work room all around the pan and box
brake.
To mount the Model M1012 to a concrete floor, do
these steps:
1. Put on safety glasses before starting!
2.
Use the holes in the feet of the supports to act as
a guide for drilling, and use the hammerdrill with
the
1
⁄
2
" bit to drill into the floor approximately 2
1
⁄
2
"
deep.
3.
Using compressed air and a vacuum hose, remove
the concrete dust from the newly drilled holes.
4.
Using the hammer and punch, pound the lag shields
into the concrete below the stand feet until flush
with the surface of the concrete.
5.
Secure the brake to the floor with the
5
⁄
16
" lag bolts
and washers.
Note:
Anchor studs (
Figure 16
) are stronger and more
permanent alternatives to lag shield anchors (
Figure
15
); however, they will stick out of the floor, which
may cause difficulties if you decide to move your
brake at a later point.
Mounting to Floor
Figure 15.
Typical lag shield anchor.
Figure 16 . Typical anchor stud.