Woodstock SHOP FOX M1012, Инструкция по эксплуатации

Страница: 27 / 36

-25-
M1012 48" Pan and Box Brake
SE
RV
IC
E
Figure 31
. Bending leaf adjustment cap
screw.
Figure 32
. Truss nut under bending wing.
2.
Use the bending leaf adjustment cap screws shown
in Figure 31 to align the bending leaf flush with the
clamp bar.
3.
Tighten the bending leaf mounting screws.
• If the entire length of the bending leaf is flush
with the clamp block, then no further adjust-
ments are necessary.
• If the bending leaf is flush with the clamp block
at both ends but is not flush in the center, then
proceed to
Step 4
.
4.
Examine the center area where the clamp block and
bending wing meet.
• If the bending wing is lower than the clamp
block, then the truss nut under the bending wing
needs to be tightened ( Figure 32) .
• If the bending wing is higher than the clamp
block, then the truss nut under the clamp block
needs to be tightened ( Figure 33 ).
5. Tighten the appropriate truss nut as determined
from
Step 4
until the bending wing and the clamp
block are flush with each other in the center.
Note : Make sure the truss nuts remain tight, because
they help stiffen the the leaf they are attached to.
Figure 33 . Truss nut under clamp block.