6.6 MATERIAL AND BLADE (JUST FOR REFERENCE)
Material
Cutting speed
(m/s)
Diameter of
scoring blade
D=250mm
Diameter of
scoring blade
D=300mm
Diameter of
scoring blade
D=350mm
Diameter of
scoring blade
D=400mm
soft woodpiece rip cutting
60-80
24W
28W
32W
36W
soft woodpiece cross cutting
60-80
40W
48W
54W
60W
hard workpiece rip cutting
60-80
24W
28W
32W
36W
hard workpiece cross cutting
60-80
40W
48W
54W
60W
veneer board
70-80
60W
72W
chipboard
50-70
40W
48W
compound board
60-80
48W
60W
72W
plywood board
50-80
40W
48W
54W
particle board
60-80
48W
60W
72W
particle board with coating
60-80
60TF
72TF
84TF
destiny board
60-80
48W
60W
72W
destiny board with coating
60-80
60W
72W
84W
fibre board
60-80
60W
72W
84W
thin board
50-70
60TF
72TF
84TF
plaster board
40-60
48W
60W
72W
Remarks: W: alternate teeth (left and right teetch)
TF: ladder flat teeth
The dimension of scoring blade: diameter=120mm, 24 teeth, ladder flat teeth, inner hole diameter=20mm
7. MAINTENANCE
WARNING
Disconnect the general power supply before doing any maintenance.
7.1 REPLACE SAW BLADE
Fig.7.1
A
B
C
D
C
- Rotate the blade lifting handwheel to move the blade to
toppest position.
- Take out the blade guard A.
- Remove the table insert B.
- Push the sliding table to backmost position.
- Open the blade cover D.
- Unscrew the nut C to take out the blade for replacement.
WARNING
Only correctly sharpened saw blades manufactured in accordance with the requirements of EN 847-1:2005 shall be
used. Don’t use the saw blade whose maximum marked speed is lower than the maximum rotational speed of the saw
spindle. Please always keep the gap between the riving knife and the saw blade to be at least 3mm and not exceed
8mm.
-17-
