-14-
5. ADJUSTMENT
WARNING
Handle the tools with protective gloves.
Fig.5.1
2mm
D
A
B
A
B
5.2 EXTENSION TABLE FLATNESS
ADJUSTMENT
Tools Required for Assembly:
- Straight edge
- Feeler gauge
- L wrench 4mm
- Wrench 16mm
- Put the straight edge B on the main table and extension
tables, use feeler gauge to check the flatness.
- Re-tighten the bolts A to micro-adjust the flatness.
Fig.5.2
A
B
E
C
D
5.3 RIP FENCE PRECISION ADJUSTMENT
Tools Required for Assembly:
- 16mm fork wrench
- Let B,C,D go through the frame, then fix on A (Don’t fix
too tight, there are 2 sets)
- Let the sliding table go through A, then align the sliding
table to the frame according to E sticker
- Position the sliding table towards the saw unit and fix the
position. Then tighten the screw.
A
C
B
D
E
Fig.4.4.7
5.1 SCORER ADJUSTMENT
For cutting panels coated with finishingmaterial, you have
to use the scorer F. Position the scoring saw blade in
order to have an engraving equal to 2mm.
Proceed as follows if it is necessary to adjust scorer
positioning with respect to the saw:
Tools Required for Assembly:
- L wrench 5mm
- Loosen the hand wheel A, then use the handle B to
adjust the saw blade height, after that, tighten the hand
wheel A
.
- Use the 5mm allen wrench to loosen the bolt D about 3
circles, then use the 5mm allen wrench to rotate the shaft
D to adjust the saw blade position, after that, tighten the
bolt D
.
CAUTION
