-16-
6.4 CORRECT USE FOR THIS MACHINE
- First make sure that the machine does not vibrate.Do
not try to take off the material when the cut has already
started; proceed with a continuous and uniform speed.
Workpiece feeding towards the blade (especially where
there are knots) should not be too fast (feeding speed
should be in accordance with workpiece thickness). Do
not let workpieces stop between the saw fence and the
blade.
- Avoid contact of the tips against metallic objects.
When necessary sharpen the saw blade.Often clean
the steel body and the tips with proper liquid products.
Let the saw blade in the bath, then clean it with brush:
don’t use metallic brushes. As regards the toothing at
least 2-3 teeth shall cut at the same time A. If only one
tooth cuts B, you don’t get a good cutting. Whenever this
is possible, it is also critical to lift the blade until the whole
tooth cutting part protrudes from the wood thickness.
WARNING
Fig.6.4
A
B
5mm
5mm
Before touching the machine parts, ensure to turn OFF
the main switch and disconnect the general power supply.
6.3.2 WORKING WITH RIP FENCE
- Lock the sliding table. Put the workpiece against the
side surface of rip fence. Push the workpiece forward
across blade.
- For your safety, please use the plastic push block.
- When cutting off a small workpiece, please use the push
stick to prevent accident cutting of hands.
Fig.6.3.2
6.5 CUTTING CHECK AFTER THE MACHINE
ADJUSTING IS FINISHED
Before cutting workpiece, please make sure the sliding
table and fence is adjusted correctly. Choose sharp and
high-quality blade. Please choose a 1000mmX1000mm
chipboard or destiny board. The board thickness should
be more than 19mm. Put the workpiece with the cutting
side close to the fence, then rotate the workpiece
anticlockwise. Cut 10mm every time, and cut 5times.
Then check the width of the fifth cutted woodpiece. The
requested tolerance should be within 0.2mm.
4
2
3
1
、
5
Fig.6.5
