Woodbridge DVI 750 (N, Инструкция по установке и эксплуатации

Страница: 25 / 40

26
If
pilot does not
stay
lit, contact a qualified
service
person or gas supplier for repairs.
Figure 9d - Remote Receiver Switch in ON Position
1.
Slide the remote receiver switch to the ON position.
This will allow the main burner to ignite.
1.
Slide the remote receiver switch to the
OFF
position.
This will turn off the main burner.
levels by using the equipment shutoff
valve.
from home for long periods of time. Heater may
come on automatically
with remote receiver
switch
i
n the "REMOTE" position.
TO TURN OFF GAS
TO APPLIANCE
1.
Tum off all electric power to
the
appliance if service
is to be
performed.
Unplug DC
adapter from
the
power
outlet.
2.
If
necessary, remove access panel from the appliance
to access manual shutoff valve on gas line.
3.
Turn
the
gas control manual valve clockwise
to the
full OFF position.
REMOTE CONTROL
OPERATION
Proflame G-Fire System Operation
Initializing the System for the First Time
1.
Install the
4
AA batteries into the receiver batter bay.
Note the polarity of the batteries and insert into the
battery bay as indicated on the battery covel' (+/-).
2. Place the 3-posilion slider switch
i
n
the REMOTE
position.
3. Insert the end of a paper clip into the hole marked
PRG on the receiver
front
cover. The receiver will
beep three times to indicate that it is ready to syn-
chronize with a transmitter.
4.
Install the
3
AAA batteries in the transmitter battery
bay located on
the
base of the transmitter.
5
.
Press
the ON
button on the transmitter. The receiver
will beep four times to indicate the
transm
i
tters
Temperature Indication Display
1.
With the system in the OFF position, press the
THERMOSTAT key and the MODE key at the same
time.
CAUTION: Do not try to adjust heating
WARNING: Make sure the remote receiver
switch is in the OFF position when you are away
Figure
2
9
b
- Remote Receiver Switch in OFF Position
Fig. 1: Proflame Transmitter.
Blue LCD display
ON/OFF Key
THERMOSTAT Key
UP/DOWN Arrow
KeyMODE Key
Manually
Turning ON the Appliance
Manually
Turning OFF the Appliance
command is accepted. The system is
now
initial-
ized.
2. Look at the LCD screen
on
the transmitter to verify
that
a °C or
°
F is visible
next
to
the room temperature.
OPERATING INSTRUCTION S
2
5
4.
If
necessary
, r
eplace
a
ccess
panel.