Setup & Operation
Assembly
Setup & Operation
PGdoc031914
2-8
2
Oiler Trough Extension
The grinder is capable of grinding blades with tooth spacing of 7/8” up to 1 1/8”.
NOTE:
A special cam is available to accommodate blades
with 5/8” tooth spacing. Call Wood-Mizer customer service
for more information.
See Figure 2-8.
To grind blades with 1 1/8” tooth spacing, the oiler trough needs to be
extended using the provided spacer plate and longer mounting bolts. To install the spacer
plate, remove the grinding wheel cover thumb screws and cover, if necessary.
Remove the existing oil trough mounting bolts and plate. Place the provided extension
plate between the existing oil trough and mounting plate. Use the longer 2 3/4” bolt in the
top hole and 2 1/4” bolt in the bottom hole to reassemble the trough.
Replace the grinding wheel cover and thumb screws.
DANGER!
Make sure all guards and covers are in place
and secured before operating the grinder. Failure to do so
may result in serious injury.
Remove the trough spacer to grind blades with less than 1 1/8” tooth spacing.
FIG. 2-8
Grinding Wheel
Cover
1/4-20 x 2 1/4"
Hex Head Bolt
1/4-20 x 2 3/4"
Hex Head Bolt
Trough
Extension
Plate
Mounting
Plate
Existing flat
washer and
lock nuts
Thumb
Screw (2)
PG0005-7
