Setup & Operation
Assembly
2
2-7
PGdoc031914
Setup & Operation
Grinding Wheel Installation
See Figure 2-7.
Remove the grinding wheel cover thumb screws and cover to access the
grinding wheel shaft.
Use the provided square socket and a socket wrench to hold the end of the grinding
wheel shaft. A hole in the drive belt cover provides access to the end of the shaft.
Unscrew the nut from the grinding wheel shaft and remove the nut and flat washer.
Loosen the top oiler mounting bolt to move the oiler out of the way.
Install the appropriate Wood-Mizer grinding wheel for the blades you plan to sharpen.
Reinstall the flat washer and nut and hand tighten to secure the grinding wheel.
If you will be grinding blades with 1 1/8” tooth spacing,
before reinstalling the grinding wheel cover. Otherwise, replace the oiler, grind-
ing wheel cover and thumb screws.
DANGER!
Make sure all guards and covers are in place
and secured before operating the grinder. Failure to do so
may result in serious injury.
FIG. 2-7
Loosen top mounting
bolt and remove oiler
Grinding Wheel
Shaft Washer
and Nut
Grinding
Wheel Cover
Thumb
Screw (2)
Shaft End
Access Hole
PG0005-8
