Wonderfire Lincoln BR517S, Руководство по установке

Страница: 22 / 32

22
13. CERAMIC COALS & WALL INSTALLATION
13.1 With its feather
edge at the top, place the
ceramic rear wall into the
channel at the back of the
firebox. Push the wall flat
against the rear of the fire
box. (See figure 37).
13.2 Fit the tray trim
over the front edge of
the burner tray. Make
sure that it is pushed
down fully.
Place the front base
coal in the burner
compartment so that
it rests on the ledges
at the sides and front.
Pull the coal forward
so that it is
immediately behind
the front rim of the
burner compartment.
(See figure 38)
.
13.3
Place the
rear base coal in the
burner compartment
behind the front coal. It
should rest on the ledge
at the back of the burner
compartment and its rear
face should touch the
rear ceramic wall (See
figure 39).
13.4 Install the 9 loose
coals as follows. The
smooth surfaces of the
coals should be at the
bottom and back.
13.4.1 Select the two
smallest coals and put
them aside until all the
other coals are installed.
Place four of the medium
size coals in the four
valleys of the front coal.
Place the left side coal so
that the pilot flame will be
visible. (See figure 40).
13.4.2
Place the three
remaining medium size
coals behind and
approximately midway
between each of the
coals in the front row
(See figure 41).
13.4.3
Place the two
remaining small coals
alongside the main coals
(See figure 42).
Fig 42 Small side coals
Fig. 41 Middle row of coals
Fig. 39 Rear base coal installation
Fig. 40 Front row of coals
Fig. 38 Tray trim & front base
coal installation
Fig. 37 Ceramic rear wall
installation