4K IP Streaming Extender
15
5.3 Video Routing Tab
Video Routing tab is used to manage video routing between TX and RX devices. There
are three modes available for Video Routing:
Genlock
The primary benefit of the Genlock mode is very low (zero-frame) latency between the
source and displays. The display is genlocked to the source as if it is directly
connected.
When Genlock is selected, what is sent out to the display is a byte-by-byte replication
of what was received from the source.
The only exception is in the occasional instance when the input video has too high a
bandwidth to fit into a 10G network link. In these cases, the video is slightly
compressed to bring the stream down below the 10G limitation of the network. An
example of a signal that is over 10G is a UHD 60Hz with full color sampling (RGB or
YCbCr 444).
Genlock Scaling
This mode combines the low latency and source locking benefits of the Genlock mode
with the output scaler found in the Fast Switch Full Screen mode.
