Then, you can check the data transmitting at the the Network / Interfaces menu, when check
the
WAN
interface status at the Interfaces part.
The router is already connected to the cellular network, it has active data traffic and the RX
(received data), TX (transmitted data) at Packets and KB (KBytes) values are growing.
At the
Advanced Settings
tab you will found further settings for the wireless module.
By default we do not offer to change these settings, only if you are special requirements at operating
the mobile network communication by the router (these are the LCP Echo settings, the Bring up
on boot and the use built-in IPv6 management parameters mainly).
If you have had changed some values here, please click upon the
Save & Apply
button for saving
the settings. Then the device will reconnecting the module to the mobile network.
3.4 USB settings (USBLAN interface)
The router has an alternative LAN interface through the USB connection. The usage of this port is
ideal for configuration purposes, while you can use active data communication throught your LAN
interfaces.
The
USBLAN
interface settings f
or the USB
Ethernet connection, which
can be performed by
Network / Interfaces menu item at the
USBLAN
part, where you need to choose the
button. Then c
hoose the
General Setup
tab.
Here you can define Protocol
(Static address or DHCP client) for getting IP address from a
connected network device (another local router).
You can define the IPv4 address of you
static connection.
The IPv6 addresses can be also used, but by default the setting of the router it is disabled by the
IPv6 assignment length (
disabled). You can allow this and add the IPv6 settings too.
