RS232
Yes
No
Data flow channel
on the RS232
serial port
No
WAN
Yes
Inactive transmission
channel on cellular
network, module not
configured / not properly
configured
-
Active data
transmission on the
4G LTE cellular network
USBLAN
Yes
No connection to the USB
port
Data flow
Connection to the USB
port
KERNEL
Yes
No
Error
Error
Group C
SIGNAL LEVEL
(
,
,
,
)
Yes
Cellular network signal strength
4 signal – Signal is above 97dBm (very good reception)
3 signal – Signal is above 85dBm (average reception)
2 signal – Signal is above 65dBm (poor reception)
1 signal – Signal is below 50dBm (weak reception)
0 signal – No signal (no reception)
Group D
LAN1
Yes
No connection on ethernet
port1 (LAN1)
Data flow
Connection through
ethernet port1
LAN2
Yes
No connection on ethernet
port2 (LAN2)
Data flow
Connection through
ethernet port2
LAN3
Yes
No connection on ethernet
port3 (LAN3)
Data flow
Connection through
ethernet port3
LAN4
Yes
No connection on ethernet
port4 (LAN4)
Data flow
Connection through
ethernet port4
2.9
Power On / Supercap Charging mode
Normal operation (DC power supply connected)
The normal usage is assigned, when you are adding power supply to the 12..24V DC connector.
The router’s PWR LED will ligting by
green
and then the ON LED will also lighting by
green
colour when the system has started.
There should be LED activity on the connected interfaces also (as USBLAN or LAN1..LAN4).
When the wireless network registration was successful and the router is on the 4G network, the
WAN LED should is also active (lighing by
green
).
