2.2
Normal startup
The router has a pre-installed system (which contains the router firmware and the pre-configured
OpenWrt
®
system).
After adding power source to the router you will just need to configure some necessary and unique
settings for your SIM card, network access, and some other required connection parameters.
Please, start the router by the following sequence.
1.
Ensure that you have inserted an activated SIM card into SIM 1 holder (No. 4) in the right
position. The usage of SIM 1 holder is obligatory to use for wireless communication.
2.
Only if you are using DUAL SIM version, insert active SIM card into SIM 2 titled holder also.
3.
Ensure that antennas are mounted to the SMA interfaces (No. 12 and 13).
4.
After plugging the DC Power source (No. 1), the router begins to perform booting – the
LED signals are always showing the current activity during the operation.
The system start needs about 40-50 seconds while it will be ready for usage, network
communication.
5.
During the boot, the router begins to operate, whereas its LED signals are showing the
current activity during the operation.
Boot sequence:
a.)
First the LAN1 – LAN4 leds are blinking for half a second, which signs that the power was
added. The PWR and ON leds are also active (lighing by
green
).
b.)
Then the RS232 and RS485 LEDs are ligthing for ~10 seconds during the firmware start.
