25
WT-9002 IP65 User Manual
WT-9002 IP65 – USER MANUAL – Rev.2.0 – Technical Support:
COPYRIGHT ©2010 WITURA CORPORATION SDN BHD
Relay 1 will now latch for 10 seconds every time it is activated (*0#) via handset, Caller
ID or SMS command (*ECL1#)
Relay 2 will now latch for 60 seconds every time it is activated (*1#) via handset or
SMS command (*ECL2#)
When relay 1 latches, the unit will display the counter on the LCD as shown.
00008
EXT WT-9002
When both relays latched…
00006
00058
EXT WT-9002
It is possible to latch both relays for up to the maximum of 65,535 seconds for a certain
time. You would use the following prompts assuming relay 1 to be latched for 30
seconds and relay 2 to be latched for 120 seconds
Once the call has connected… (With a short beep ~ prompt the administrator to enter
password, the initial set up password is 123456 by default)
After enter password… (Another short beep ~ Password Correct)
Press *6# (A short beep ~ success)
Continue press 1# for relay 1 (A short beep ~ success)
Then input value 00030# (A short beep ~ success)
Relay 1 will now latch for 30 seconds and after 30 seconds it will switch off and sends a
message back to the administrator informed that Relay 1 has closed.
Returned Message:
RLY1-OFF
4.18 TEMPORARY LATCHES THE RELAYS VIA PHONE CALL
