16
WT-9002 IP65 User Manual
WT-9002 IP65 – USER MANUAL – Rev.2.0 – Technical Support:
COPYRIGHT ©2010 WITURA CORPORATION SDN BHD
Then input the current password 123456# (you should hear a short beep ~success)
Continue to enter new password 654321# for 2 times (another short beep if password
entered correctly)
If the change has not been successful you will hear 3 beeps and must re-enter
again.
The system only allows the 3 administrators to change the 6 digits password.
To change the password from the factory default 123456 to 654321 (Example) you can
just send the following SMS to the unit.
Example:
Sends a SMS Command: *PAWO#654321
If the change is successfully, the system will display “OK” on the screen and the
administrator will receive a reply message from the unit.
Returned Message:
PAWO-OK
It is possible to change any of the administrator numbers using the following prompts on
the keypad and making the following three calls to the unit assuming the following 3
numbers are to be changed as.
Example:
Change TEL1 to 4444444444
Change TEL2 to 5555555555
Change TEL3 to 6666666666
Once the call has connected… (With a short beep ~ prompt the administrator to enter
password, the initial set up password is 123456 by default)
4.6
CHANGING THE PASSWORD VIA SMS
4.7
CHANGING THE ADMINISTRATOR NUMBERS VIA VOICE
