28
WT-9002 IP65 User Manual
WT-9002 IP65 – USER MANUAL – Rev.2.0 – Technical Support:
COPYRIGHT ©2010 WITURA CORPORATION SDN BHD
To view the actual admin numbers programmed in you would just call the unit and
prompt the following to view all 3 numbers.
Once the call has connected… (With a short beep ~ prompt the administrator to enter
password, the initial set up password is 123456 by default)
After enter password… (Another short beep ~Password Correct)
Press *7# (beep) and press 1# and the display will show you number 1 for 10 seconds
Press *7# (beep) and press 2# and the display will show you number 2 for 10 seconds
Press *7# (beep) and press 3# and the display will show you number 3 for 10 seconds
It is possible to control the access of administrator or user to the system by sending the
following SMS command to the unit.
Sending SMS Command *ANY?#1, the system will allow only the administrators to gain
access to the system and the authorized users in this case will not allow to access the
system. (Factory Default: *ANY?#0 ~ Any person can gain access to the system)
Note: It is advised that the owner should set the system to allow access only
for administrators after programmed the Administrator numbers. Only the
Administrator numbers in the list can send this command.
Sending SMS Command *TEL?#1, the system will Not receive phone call from both
administrators and users but will activate relay 1 immediately. (Factory Default:
*TEL?#0 ~ able to receive phone call only from administrator but will not activate relay
1 immediately)
It is possible to turn ON/OFF the request of report message when inputs triggered from
the unit by sending the following SMS command to the unit.
4.21 DISPLAY
PROGRAMMED ADMINISTRATOR NUMBER
4.22 ACCESS CONTROL FOR ADMINISTRATOR AND USER
4.23 TURN ON/OFF SMS REPORT FROM THE UNIT
