3.1
Fastening of the safety gear
To fasten the safety gear the in the delivery inclu-
ded srews and bushings must be used. If this is not
the case, note the following criterias:
If the screws are too short (thread engage-
ment <11mm) a secure fixing of the safety
gear isn’t guaranteed.
If the screws are too long (thread engage-
ment >13mm) the proper function of the
safety gear isn’t guaranteed.
Shim washers can be used to adjust the
thread engagement.
3.2
Movement of the safety gear
The safety gear must be able to move hori-
zontally.
Therefore the delivered bushings must be used.
Use this bushings (1) to fix the safety gear (2) on a
fixing plate (3)*) in slotted holes (4).
So the safety gear can be screwed with the fixing
screws and the safety gear can still move horizon-
tally.
Additional the safety gear must be held in position
with a spring*) (force at installation length 66N,
spring rate 2N/mm) and a variable adjustable stop
collar (6) must be in the opposite side.
*) not in the standard content of supply (with
optional housing included in delivery)
Änderungen vorbehalten!
Subject to change without notice!
3
Installation and adjustment
© WITTUR – All rights reserved
Observe tightening torque!
Screw M12: 80 Nm
Progressive Type Safety Gear
CSGB-01C
Operating instructions
Blatt/
sheet
PM.7.003609.EN.008
Datum/
date
14.07.2016
Stand/
version
Geprüft/
approved
WAT/MZE
A-02.05.2017
