Änderungen vorbehalten!
Subject to change without notice!
© WITTUR – All rights reserved
3.6
Gripping wedge synchronization
and adjustment
After installation of the car frame and the guides,
the correct centering and adjustment of the safe-
ty gear in accordance to the rails has to be done.
When mounting the safety gear, observe
the position of the overspeed governor
rope. The position of the lifting lever of the
rope at the safety gear cannot be changed
if the safety gear is built-in.
(
1
) Check that the tripping wedge is in the normal
position (10).
If necessary readjust by use of the screw (11)
on the opposite side of the governor rope
hitch.
If necessary adjust the synchronization in
accordance with the instructions for the
car frame or the counter weight safety
gear.
The adjustment screws of the synchro-
nization must be easily accessible.
(
2
) Activate the synchronization by hand and
check that both safety gears are activated at
the same time.
(
3
) Check the horizontal movement of the safety
gear to be sure that the brake lining is able to
access the guide rail when the safety gear is
activated.
(
4
) Check the horizontal adjustment of the safety
gear.
(1-3)
y
x
(4)
(x)
2,5
+/-0,5
x
4
+/-2
y
CSGB-01C
Progressive Type Safety Gear
CSGB-01C
Operating instructions
Blatt/
sheet
PM.7.003609.EN.011
Datum/
date
14.07.2016
Stand/
version
Geprüft/
approved
WAT/MZE
A-02.05.2017
