TP
+
Technical data sheets
Revision: 03
2022-D036009
en-7
Do not use washers (e.g. plain washers, tooth lock washers).
For prescribed screw sizes and torques refer to Chapter 3.10 "Specifications on mounting
onto a machine", table "Tbl-9".
3.6
Mounted components on the gear output side
For prescribed screw sizes and tightening torques refer to Chapter 3.11 "Specifications on
mounting on the gear output side", table "Tbl-10".
3.7
Startup and operation
3.8
Notes on the lubricant used
The manufacturer listed below will provide any further information on the lubricants:
Distortions during mounting operations can damage the gearhead.
Mount gearwheels and toothed belt pulleys onto the output flange
without forcing.
Do not on any account attempt an assembly by force or hammering!
Only use suitable tools and equipment for assembly.
Improper use can cause damage to the gearhead.
Make sure that
- the
ambient temperature
does not drop below –15 °C or exceed
+40 °C and
- the
operating temperature
does not 90 °C.
Avoid icing, which can damage the seals.
For other conditions of use, consult our Customer Service department.
Only use the gearhead only up to its maximum limit values, see
Chapter 3.13 "Performance statistics".
Only use the gearhead only in a clean, dust-free and dry environment.
All gearheads are permanently lubricated by the manufacturer with
synthetic gear oil (polyglycols) of viscosity class ISO VG100, ISO VG220 or
with a high-performance lubricant (see type plate). All bearings are
permanently lubricated by the company.
Standard lubricants
Lubricants for the food industry
(NSF-H1 registered)
Castrol Industrie GmbH, Mönchengladbach
Tel.: + 49 2161 909-30
www.castrol.com
Klüber Lubrication München KG, Munich
Tel.: + 49 89 7876–0
www.klueber.com
Tbl-6: Lubricant manufacturers
