Witt W5-450MF, Руководство пользователя

Страница: 80 / 86

79
Important:
•
Do not modify the outer panels of this appliance in any way.
•
Fixing screws - The fixing screws are in a polythene bag in the oven pack.
•
Depending on the method of installation, some of the screws may not be needed.
•
If you have a non standard size of cabinet which leaves a gap above or below the appliance, you may be
able tobuy a trim kit (to fill in the gap) from the supplier of your cabinets.
•
Remove the fixing screws from the polythene bag on the top of the appliance, but leave the appliance in
the base
•
tray packaging until you are ready to install it.
•
Note: When removing the appliance from the base tray packaging care should be taken not to damage
the appliance.
•
When installing in a typical 600mm deep, built in housing unit, the false back should be removed from
the housing unit to provide the necessary depth for installation.
•
When the false back is removed, it is normally the case that the support shelf for the appliance leaves a
gap between the back edge and the wall of approximately 80mm.
•
If no gap occurs between the back edge of the shelf and the wall behind the unit, we recommend that a
gap of at least 30mm is made by shortening the shelf.
•
The appliance is designed to fit into a standard 600mm wide housing unit, with minimum internal
dimensions as shown.
•
Please note that all sizes are nominal, and some variation is to be expected.
Installing appliance under a worktop
•
Where the appliance is installed under a worktop, with a hob installed above it, the installation
instructions for the hob must be read in conjunction with these instructions.
•
When installing a gas hob above the appliance, care must be taken to ensure the hob inlet pipe is as close
to the back wall as possible, so it doesn’t obstruct the appliance or the appliance inlet pipe.
•
If a flexible inlet pipe is used, it must hang vertically and not be trapped between the oven and rear wall.
Connecting the electricity supply
•
We recommend that the appliance is connected by a qualified electrician who will comply with the I.E.E.
and local regulations.
Securing the appliance
•
This appliance must be securely fixed into the cabinetry. Use the screws supplied to fix the appliance to
the cabinetry through the holes in the front frame.