Witt 61650038, Руководство пользователя

Страница: 18 / 72

18
9. The “ADD WATER” indicator will light up when the water reservoir is lack of water
and the ice-making cycle will stop automatically. At that time, remove the ice
basket and add water to the water reservoir, and then press “ON/OFF” key again
to restart the
ice-making cycle. The appliance will start working automatically after about 30
minutes if the operator forgets to restart the appliance after refill.
10. When you have got your desired amount of ice, stop the ice making cycle by
pressing the “ON/OFF” key and unplug the unit from the wall outlet.
11. Open the top lid and transfer the ice to a freezer.
12. Allow the ice maker to reach room temperature.
13. Suggest replacing the water every a week. Please empty the water reservoir if
the ice maker is not used for a long time.
Cleaning and maintenance
1. Stop the ice-making cycle by pressing the “ON/OFF” key, unplug the ice maker
from the wall outlet and allow it to warm up to room temperature.
2. Tilt the whole unit for about 30°and move it forward to the place where the drain
plug is about 60mm away from the countertop. Open the drain plug and drain the
excess water (see Fig.1).
3. Remove the ice basket.
4. Clean the ice maker interior with a soft cloth soaked with warm water and
vinegar, then rinse with clean water and then drain all the water.
5. Replace the drain plug well in position. Wash the ice basket and ice scoop in
warm soapy water. Rinse and dry.
6. Clean the exterior of the ice maker with a soft damp cloth. Use a mild
dishwashing soap, if necessary.
NOTE: Do not use organic solvent, boiled water, detergent, strong acid and
strong alkali etc. for cleaning.
7. Please empty the water reservoir and dry it for storage if the ice maker is not
used for a long time.
Countertop
Drain plug Drain plug
Fig. 1
Drain plug
8. Deep cleaning
Fill the Ice Cube Maker with lukewarm water and a
teaspoon of vinegar up to the MAX line.
Select ‘CLEAN’ and then press the ‘ON/OFF’ button
to start the cleaning programme.
We recommend that you deep clean the Ice Cube
Maker once per week if using it on a daily basis.
When the programme starts, the ‘CLEAN’ display
will show constantly and it will start blinking once
the cleaning programme has been completed.
A cleaning process takes around 60-65 seconds and
the cycle will progress automatically (5 cycles).
When the cleaning programme is completed, empty
the water with the vinegar and then fill the beholder
up to the MAX line with clean water.
Run the ‘CLEAN’ programme again to flush out the
device.