17
BEFORE FIRST USE
1. Unpack the appliance, then check and make sure that all the accessories
including ice basket and ice scoop etc. are complete. Please contact with the
client service department if some accessories are missed.
2. Please ensure the ice maker is level and on a stable table or platform to avoid
malfunction.
3. The incline angle of the ice maker cabinet should not exceed 45°during
transportation or use. Do not turn the ice maker upside down. Doing so could
cause the compressor or refrigerating system to operate incorrectly. Please allow
time for the fluids in the compressor to settle after the ice maker is moved or
transported. Before using the ice maker for the first time, please wait for 2 hours
after the unit has been leveled and positioned in the proper place.
4. The appliance must be placed on a dry and level surface with sufficient
ventilation, far from heat sources such as ovens, heaters and corrosive gases.
Leave about a 6-inch (15cm) clearance on all sides of the ice maker for proper
ventilation.
5. Do not fill the water reservoir with hot water. This may damage the ice maker. It is
best to fill the water reservoir with water of room temperature or lower.
6. Do not use the appliance at a very cold environment (lower than 5 ºC).
7. Clean the appliance by following the operation of “CLEANING AND
MAINTENANCE” before operate.
Using your ice maker
1. Plug the ice maker into the wall outlet, the “POWER” indicator blinks.
NOTE: Please make the ice maker be rested for 30 minutes before plug if it has
been moved.
2. Open the top lid and remove the ice basket.
3. Fill the water reservoir with drinking water.
NOTE:
Do not fill above the MAX water level mark.
4. Replace the ice basket and close the top lid.
5. Press “ON/OFF” key, and the “POWER” indicator lights solidly. At that time,
press ”SELECT” key to select the ice size. If need to clean the appliance, press
“SELECT” key to select “CLEAN” function under standby mode.
6. The ice-making cycle will last approximately 6-15 minutes, depending on the
ambient temperature and water temperature.
7. The ice-making cycle starts with water being pumped into the ice tray situated
below the evaporator. Over the next 6-15 minutes ice forms on the evaporator.
Once this has completed, the ice tray will tilt backwards and the remaining water
in the ice tray is drained back into the water reservoir. The ice cubes are then
dropped from the evaporator and pushed forward into the ice basket by the ice
shovel. The ice tray will automatically move back into position under the evapo-
rator and start the next cycle.
8. The “ICE FULL” indicator will light up when the ice basket is full and then the
ice maker will stop the ice-making cycle automatically. Gently remove the ice
from the ice basket with the ice scoop. About 5 seconds later, the ice maker will
restart its ice making function automatically.
EN
EN
Содержание 61650038
Страница 62: ...62...
