the searchlight at people. Before you turn on the searchlight
make sure that nobody is in front of the searchlight.
1. Turn the main power switch S8 on the PSUH power supply
unit to position ON. This supplies power to the searchlights
internal heating system and the heater of the optional drive
unit.
Attention!
If ambient temperatures are below 6°C, wait until
housing interior has been heated to at least 6 °C before
igniting the lamp.
Before you ignite the lamp make sure that all work has been
completed and nobody is in front of the searchlight.
2. Turn on switch S1. The lamp will ignite
3. In case you operate the searchlight by means of an
electromechanical drive unit, you should turn it on with
switch S2, which is also located on the RCU. The drive
unit in now operational and can be controlled by means of
the joystick on the RCU.
→
If the lamp does not initiate or if it flashes a number of
times, there is either insufficient ignition voltage for the
lamp or the lamp is defective.
See chapter 7.3
Changing the lamp
for more information on
replacing the lamp.
5.3 Turning off the searchlight
Attention!
To ensure operational readiness: only turn off the
searchlight using the S1 and, if you work with an RCU, with
the S2 switch on the control unit.
Do not turn off the S8 switch on the power supply unit
because the internal heaters should stay on all the time.
Operation
SH400-575 Rev.230903E
22
SH400-57
5 Rev.
230903E
Содержание SH400
Страница 2: ...About this manual SH400 575 Rev 230903E 2 SH400 575 Rev 230903E ...
Страница 15: ...Power supply unit PSUH inside SH400 575 Rev 230903E Overview 15 SH400 575 Rev 230903E ...
Страница 17: ...Circuit diagram with drive unit and Remote control SH400 575 Rev 230903E Overview 17 SH400 575 Rev 230903E ...
