4.3 Electrical connections
Danger of electrical shock!
Electrical connections may only
be completed by qualified personal. Be sure the power cord is
dead and nobody can accidental resume the power supply
during installation!
The circuit diagram is enclosed separately or you find it in
chapter 3.5
Diagram
.
Connected load values
Supply voltage: 230 V, 50/60 Hz.
Unit Fuse: 1 x 16A included.
Waterproof (IP56) installation of all cables
1. Unscrew the cover on the underside of the PSUH power
supply unit and remove.
2. Drill holes matching the cable size and insert cable fittings
into holes.
3. Feed cable through the cable fittings and fasten firmly.
Attention!
To ensure that the protection class IP56 is
maintained:
The cable sheathing must have a waterproof seal: pull the
fittings firmly into place so that the seals are wrapped tightly
around the cable fitting!
4.
Connect cables in accordance with the circuit diagram
(see separate circuit diagram or chapter 3.5
Circuit
diagram
).
Note:
The cable from the searchlight and FL51 drive unit can
be connected directly to the power supply unit (PSUH) or via a
junction box.
Power supply
•
Be sure to observe any applicable international or local
country regulations! Connect to the power supply while
ensuring reverse polarity protection!
Before first use:
•
Check that installation has been carried out correctly.
Wrong connections may destroy the searchlight unit as
well as the Metal Halid lamp.
•
Check to be sure that grounding and zero current works
properly!
• Reinsert
fuses.
Installation
SH400-575 Rev.230903E
20
SH400-57
5 Rev.
230903E
Содержание SH400
Страница 2: ...About this manual SH400 575 Rev 230903E 2 SH400 575 Rev 230903E ...
Страница 15: ...Power supply unit PSUH inside SH400 575 Rev 230903E Overview 15 SH400 575 Rev 230903E ...
Страница 17: ...Circuit diagram with drive unit and Remote control SH400 575 Rev 230903E Overview 17 SH400 575 Rev 230903E ...
