WISKA SH400, Руководство по эксплуатации

Страница: 19 / 32

Installing on a low base or a column equipped with
internal mechanical operation
As an option the configuration with low base or column can be
equipped with an additional internal mechanical operation.
The mechanical linkage runs in an internal pipe of the low
base or column. Consequently the pipe must be brought
down. To do so, an additional hole for the
ø 50 mm pipe has
to be drilled in the middle of the ø 300 mm circle.
See also chapter 3.4
Dimensions
.
Installing the remote control unit RCU
If the searchlight is equipped with an electromechanical drive
unit, a remote control unit is required also.
The control unit is available as panel mount unit RCU-E and
as wall mount unit RCU-A. Electrically and functionally both
units are identical.
To install the units drill the required holes and make opening
if required as shown in chapter 3.4
Dimensions .
Be sure to provide wire of sufficient size (cross-section) for the
cable length.
Installing the power supply unit PSUH
At least two persons are required for installation due to the
weight of the PSUH.
Be sure to observe the instructions in chapter 2.4
Operating
requirements
on where to install the power supply unit.
The Power supply unit comes with four brackets for wall
mounting.
The searchlight and the drive unit come with a 3 m power
cable. If the PSUH is installed farther away from the
searchlight, bear in mind that the supply voltage for the PSUH
must be 230 V.
Installing the remote control unit RCU
If the searchlight is equipped with an electromechanical drive
unit, a control unit is required also.
The control unit is available as panel mount unit RCU-E and
as wall mount unit RCU-A. Electrically and functionally both
units are identical.
To install the units drill the required holes and make opening
if required, as shown in chapter 3.4
Dimensions
.
Be sure to provide wire of sufficient size (cross-section) for the
cable length.
SH400-575 Rev.230903E Installation
19
SH400-57
5 Rev.
230903E