Wisenet PNM-9322VQP, Руководство пользователя

Страница: 15 / 28

English _
15
!
INST
ALLA
TION & CONNECTION
How to set up channels to monitor for installation
The camera body has a channel DIP switch, as shown in the figure.
You can change the channel of the camera using the channel DIP switches.
CH1 CH2 CH3 CH4
00 01 10 11
M
`
If a DIP switch is not fully On/Off, the product may malfunction. After installation, check the DIP switches at the back.
`
Be careful, as you will risk damaging a DIP switch if you manipulate it using a sharp tool.
`
Be careful, as a DIP switch may be damaged if you operate it with excessive force.
Connecting the installation monitor
Connect the Test Monitor Out Port of this product to the video input terminal of the monitor for installation.
` The wiring varies depending on your monitor type and peripheral devices; please refer to the user manual for each device.
` Please make sure the monitor and camera are turned off when connecting them.
J ` This product is a network camera that transfers video over a network; the Test Monitor Out Port is used to set the imaging
range of the camera at installation.
`
Using the terminal for monitoring purposes may cause problems such as degradation in video quality.
`
It is not suitable for 24-hour monitoring using professional CRT monitors or TFT/LCD portable monitors.
`
Use the network transfer screen for 24-hour monitoring and storage.
`
You can only check the videos of the 4CH lens module, not the videos of the PTZ.
`
After mounting the lens module, make sure all four channels are working properly.
-
If any of those channels is flipped, a PTZ calibration error occurs.
Monitor