installation & connection
14_
installation & connection
3.
Connect the network, I/O, and audio cable to the I/F
PCB.
J
`
For smooth joining with the PTZ camera, please be careful
with the shape and form.
(After joining the camera, the cable might be tangled as the I/F
PCB rotates.)
4.
After fastening the I/F PCB to the body, install the safety wire of
the camera body to the installed base.
5.
Join the installed base and the camera body by matching the
Installation direction guides.
6.
Turn the camera in the direction of the arrow so that the installation direction guides at the top and bottom
are placed as shown below.
7.
Use the screw bit(Torx 30) to secure the installed base and
the camera.
8.
Adjust the lens to the desired direction by referring to
“
Adjusting the monitoring direction for the camera
”.
(Page 16)
`
If you tilt the lens, you may need to adjust the lens as this may block the
screen.
9.
Use the Torx L wrench or screw bit(Torx 20) to join the
window cover.
J
`
Use the Torx L wrench or screw bit to firmly tighten the fastening
bolts so that there is no water damage issue.
`
Since the window cover is transparent, there is no safety wire.
Please be careful not to drop it.
I/F PCB
x3
x3
Содержание PNM-9322VQP
Страница 28: ......
