Wisenet PNM-9322VQP, Руководство пользователя

Страница: 12 / 28

installation & connection
12_
installation & connection
Mounting lens module
1. Remove the cap from the lens module
mounting portion.
2. Align and fasten the connector of the lens
module with the connector of the camera
body.
J
`
Install the lens module while power is not
connected (HPoE).
`
Make sure the power switch is “
OFF
” before
installing the lens module. Replacing the lens
module while it is “
ON
” can cause malfunction.
`
You are recommended to avoid touching
the lens separately, as it is shipped from the
factory with the focus adjusted during the
manufacturing inspection.
J
`
When inserting the lens module, insert it until the top/
bottom hooks “
click
”.
`
After mounting the lens module, make sure all four
channels are working properly.
-
If any of those channels is flipped, a PTZ calibration
error occurs.
3. Complete the lens mounting process.
4. Connect power to the product (HPoE).
J ` If the lens module is not attached correctly, the lens module
status light will illuminate red, as shown in the figure. If
this occurs, turn off the power switch and reattach the lens
module.
If attached normally, it will illuminate green and then turn off
after approximately 40 seconds.
` If you want to replace the lens module while connecting
power to the product (HPoE), turn the power switch “
OFF
”,
replace the lens module, and then turn the power switch “ ON ”.
`
Be careful not to use any tool with a sharp point when handling
the switch since it might be damaged.
`
Be careful not to forcefully handle the switch since it might be
damaged.
Removing a Micro SD card
1. Gently press down on the exposed end of the Micro SD
card as shown in the figure below to eject the Micro SD
card from the slot.
J
`
You should save an Micro SD card for each channel.
`
Before removing the Micro SD card, in < Setup ( ) > -
< Event > - < Storage >, set the device to < Off > and press the
[ Apply ] button and turn the camera off.
`
If you turn off the camera or remove the Micro SD card that
contains data from the product, the data may be lost or
damaged.
2. Using the Torx L wrench or screw bit(Torx 20), join the
dome cover and the micro SD card cover.
J ` Use the Torx L wrench or screw bit to firmly tighten the fastening
bolts so that there is no water damage issue.
x3