WIR elektronik eWickler Comfort eW910, Инструкция по эксплуатации

Страница: 6 / 18

10
INSTALLATION PREPARATIONS INSTALLATION PREPARATIONS
11
1.
Remove the old swivel belt winder:
Close the roller shutter entirely, dismantle the
belt winder from the wall and unwind the belt.
Please be careful with the spring can. The
spring is under high tension and may cause se-
rious injury.
2.
Shorten the belt approx. 20 cm under-
neath the swivel belt winder’s position on
the wall.
3.
Double the end of the belt (approx. 2-3 cm)
and use scissors to cut a slit for later mounting it
onto the winding wheel.
4.
If necessary, install a return pulley at the
roller shutter box. Thus you avoid unnecessary
attrition/wearing down.
zu trennen und
-
Safety instructions concerning the electrical
connection/ warning notice
When you install electrical devices, there is
always a life-threatening danger. Assembly of
electrical systems must be carried out by qua-
lifi ed electricians (electrical shops).
If the mains supply line of this device gets dama-
ged, it must be exchanged with a special supply
line which is available from the manufacturer.
All the other installation tasks must be carried
out in no-voltage condition. Therefore it is im-
portant to disconnect all supply cables from the
power system and safeguard them against un-
intentional reconnection. Establishing an electrical connection
1.
Connect the enclosed cable. Please make
sure to lay the cable fi rmly and securely but
without damaging it (danger of a short-circuit).
Inserting and mounting the belt
Connect the power plug with the mains supply.
2.
Press the Up-button till the fi xing hook is
accessible in the winding wheel casing.
Careful! Do not put your fi ngers into the
winding wheel casing while the motor is
running.
Elektrischer Anschluss Gurtband einlegen und befestigen