（
4
）
Clean the bare part With
another alcohol tissue.
]
Check
：
After this operation,handle
the fiber so as not to damage
its bare glass.
]
Check:
Use
a
high-quality
alcohol,greater than 99%
pure.
]
Check: Change lint-free tissue or
gauze each time
（
5
）
Cleave the fiber with a fiber cleaver,Refer to page21
§
4.4.4
]
Note
：
Cleave length
：
16mm
。
]
Note
：
Do not clean the fiber after cleaving.
STEP3
：
Set the fiber in the splicer.
（
l
）
Gently set the stripped fiber in the V-groove.
]
Check
：
Set the fiber end-face between the V-groove tip and
electrode center line.
（
2
）
Gently close the sheath clamp.
（
3
）
Close the wind protector.
STEP4
：
Select Suited Splicer Mode
Press
＜
＞
into the setup program menu,
“
Select Program
”
be
selected suited splicer program of 3 column .Refer page 50
§
6.4
Select Program
STEP5
：
Splicing operation
Press
＜
＞
to start splicing. Refer to page 26
§
4.6
Splicing operation
STEP6
：
Fiber removal
（
1
）
Open the wind protector
（
2
）
Open the left and right sheath clamp
，
Remove the fiber.
Page 15
Fibe
Pass Fiber
Tension Member
Fiber protection sleeve
Fig.3-1
Pass Fiber
Full operation refer
right Fig.3-2
①
Clean Fiber
③
Remove Coating
④
Clean Bare glass
⑤
Cleaving Fiber
Bare Fiber
②
Pass Fiber
Fiber protection sleeve
Fiber melt sleeve
Tension Member
Coating
Fig.3-2
Fiber Stripping
Page 16
