off,and disconnect the AC power cord,or remove the battery pack when
replacing the electrodes.(Note: Opening the wind protector stops arc
discharge.)
14
．
Do not disassemble or modify the splicer,AC adapter,battery pack,or
DC adapter. In particular,do nor remove or bypass any electrical or
mechanical safety device (e.g.,fuse or safety switch)incorporated
in this equipment. Modification could cause damage that may result
in personal injury,death or electric shock or fire.
15
．
Use only the 85-264VAC,47-63Hz/12VDC,14Ah with WY-725.
.The proper supply voltage source is 85-264VAC,47-63Hz,Check the AC Power
source before use.Using an improper AC power source may cause fuming,
electric shock or equipment damage and may result in personal injury, death
or fire.
16.Use the supplied AC power cord. Do not place heavy objects on the
AC power cord. Do not pull, heat up or modify the AC power cord. Use
of an improper cord or a damaged cord may cause fuming, electric shock
or equipment damage and may result in personal injury, death or fire.
17.Connect the AC power cord properly to the splicer and wall socket.
When inserting the AC plug, make sure there is no dust or dirt on
the terminals. Incomplete engagement may cause fuming, electric
shock or equipment damage and may result in personal I jury, death
or fire.
18.The WY-725 uses a three-prong(core) AC cord that contains an earthed
ground safety mechanism. The splicer MUST be Grounded/Earthed. Use
only the supplied three-prong(core) AC power cord. NEVER use a
two-prong(core) power cord, extension cable or plug.
19.Use only the approved battery pack with the WY-725. Only the
WY-725-01 battery pack can be used as the approved battery pack.
20.Use the specified charger cord(WY-725-09) to recharge the battery
pack (WY-725-01). Using other battery chargers and charger cords may
cause fuming or equipment damage and result in personal injury,death
or fire.
21.The splicer inlet is used to disconnect the power cord in the event
of a fault. Be sure to position the splicer so that the power cord
can be disconnected easily and quickly.
22.Disconnect the AC or DC power cord from the splicer inlet or the
wall socket(outlet)immediately if the splicer or the external
battery emits fumes or bad smell, or becomes noisy or hot. Leaving
the abnormal condition unattended will cause equipment
failure,electric shock or fire and may result in personal
injury,death or fire.
23. Disconnect the AC or DC power cord from the splicer inlet or the
wall socket (outlet) if the splicer becomes damaged (e.g., by
dropping).Leaving the splicer in a damaged state may cause equipment
failure,electric shock or fire and may result in personal
injury,death or fire.
24
．
Disconnect the AC or DC power cord from the splicer inlet or the
wall socket(outlet)immediately if liquid (e.g.,water) or foreign
matter (e.g.,screw) enters the splicer. Leaving the splicer in a
damaged state may cause equipment failure,electric shock or fire and
may result in personal injury,death or fire.
25.Caution should be taken when removing the fiber protection sleeve
from the tube heater after the heat shrink cycle is completed. The
Page 3
Page 4
