STEP7
：
Reinforce the splice.
（
l
）
Slide the fiber protection sleeve to the center of the splice
and move it to the tube heater.
]
Check
：
Make sure the splice point and fiber protection sleeve
are in the center of the tube heater.
]
Check
：
Make sure the reinforcing material is placed dow.
]
Check
：
Make sure the fiber is not twisted.
（
2
）
While applying tension to the fiber, lower the fiber into
the tube heater, the left tube heater clamp will close
automatically.
（
3
）
With tension still applied to fiber, close the right tube
heater clamp with your left hand.
（
4
）
Press
＜
＞
to start tube-heating cycle.
§
4
．
Detail of Splicing Operation
§
4
．
1
．
Preparations before Splicing Operation
Prepare necessary items
，
referring to page 7
§
2.3 Other
Necessary Items for Splice Operation
§
4
．
2.Power Supply
Three supplying power to the WY-725: AC Power supply
、
internal
battery
、
external battery .
a
Warning
：
Follow safety instructions
，
refer to the page 1 to 5
§
1 Warnings and Cautions for Safe Operation
§
4
．
2
．
1
．
Using AC Power supply
To operate the splicer from an AC power supply 176
～
264VAC
，
47
～
63Hz
（
l
）
Confirmation before operation
a
Check
：
Make sure the power source is 176
～
264VAC
，
47
～
63Hz.When
connecting to an AC generator, always check the output voltage
of the generator with a circuit tester before connecting the AC
power cord.
a
Check
：
Make sure the AC power cord is free from damage,etc.
(2)Plug AC adapter into splicer.
(3 )Plug the AC power cord
（
WY-725-03
）
into the AC adapter inlet
，
Make sure plug is fully seated and in the correct position.
(4)Plug the AC power cord into the wall socket. Make sure plug is fully
seated and in the correct position.
(5)Press<
>,turn on splice.
Page 17
Page 18
