§
4
．
4
．
3
．
Stripping and Cleaning
(1)Remove the fiber coating 30-40mm with a stripping tool.
a
Check
：
After this operation, handle the fiber so as not to damage
its bare glass.
（
2
）
Clean the bare part of the fiber with another alcohol-impregnated
gauze or lint-free tissue.
a
Check
：
After this operation, handle the fiber so as not to damage
its bare glass.
a
Check
：
Use a high quality alcohol, greater than 99% pure.
a
Check
：
Change gauze or lint-free tissue each time.
§
4
．
4
．
4
．
Fiber Cleaving
a
Note
：
The cleave length is 16mm
Notes: detail steps ,Please refer to the fiber cleaver instruction
§
4
．
5
．
Setting Fiber in Splicer
（
1
）
Open the wind protector.
（
2
）
Open the left and right sheath clamps.
（
3
）
Place fiber in the V-groove.
a
Check
：
Make sure the fiber is not twisted when setting it into
the splicer.
a
Check
：
If the fiber coating has curl memory, or bend memory, Load
the fiber in such a manner that the crown (curve) of the
memory is turn upward.
a
Check
：
Care should be taken to prevent damage or contamination
of the fiber end-face. Fiber end-face contact on ANY item
including V-groove bottom may result in poor quality
splices.
Fig.4-3 Setting Fibers I
（
4
）
Gently close the sheath clamp while holding the fiber.
Page 23
Page 24
