Wintriss Shadow 8, Руководство пользователя

Страница: 58 / 159

Shadow 8 User Manual 1139300
Installation and Checkout 2-33
2.
Run the cables from the receiver and transmitter to the knockouts in the top of the control.
The receiver cable will be inserted into the top center knockout, the transmitter cable into
the top right knockout. If you want to install cabling in liquid-tight conduit, refer to
Figure A at the end of the manual for a drawing and parts list.
3.
Open the control by pulling up on and turning the hinge to unlock the clasp.
4.
Locate terminal blocks TB2 (receiver) and TB20 (transmitter) on the Shadow 8 Main
board (see Figure 2-20).
5.
Measure the wires to fit and cut the wires as necessary. Allow 4 1/2 in. at the end of the
cable for connections at the control.
6.
Thread the receiver cable through the hole in the top of the plastic gland nut (see
Figure 2-21), then through the hole in the tapered end of the threaded coupling. Slide both
components well down the cable so they are out of the way.
7.
Remove the first 4 1/2 in. of black PVC insulation from the conductors, using an Exacto
knife. First, make a shallow incision around the circumference of the cable, then bend the
insulation back and forth at the incision point and pull the 4 1/2 in. length of insulation
free.
8.
Slide the gland nut cap and threaded coupling down the cable (i.e., toward the control)
until the end of the coupling is flush with the point at which you cut the cable. Thread the
cap onto the coupling, and tighten the two components by hand, securing the cable as you
do so.
9.
Tighten the cap onto the coupling, using a 1 1/16 in. (27 mm) wrench.
10.
Remove 3/16 to 1/4 in. of insulation from the ends of each conductor wire, using a wire
stripper.
Figure 2-21. Cable Being Threaded through Top of Gland Nut and Threaded Coupling
When removing insulation, be careful not to cut into the conductors.
When tightening the gland nut cap and coupling, make sure to turn cap and coupling in
opposite directions at the same time.
To receiver or
transmitter
Cap Threaded coupling
To control
Cable
Rubber washer
NOTICE
NOTICE