Wintriss Shadow 8, Руководство пользователя

Страница: 63 / 159

1139300 Shadow 8 User Manual
2-38 Installation and Checkout
2.
Determine how you will bring wiring from your 115 Vac power source (or 230 Vac source,
if applicable) to the appropriate knockout at the bottom of the unit. These wires should be
connected directly to the press control transformer. For 115 Vac, you need three wires—
high (black), neutral (white) and ground (green). For 230 Vac, high and neutral wires are
black and red, the ground wire green or green-and-yellow.
3.
Run the power wires to the control box. If your stop circuits are 115 Vac, the AC wiring
and stop circuits will be run through the same flexible, liquid-tight conduit and will enter
the enclosure ideally through the bottom middle knockout. If the stop circuits are 24 Vdc,
then 115-230 Vac wiring will enter through the bottom left knockout and the 24 Vdc wires
through the bottom right knockout. To maintain the control box’s IP65 rating, you must
use conduit of the same rating and make proper connections to the control.
4.
Remove the knockout(s) you plan to use for your AC wiring and stop circuits. Left and
center knockouts are combo units (0.875 in. (22.2 mm) ID, 1.13 in. (28.7 mm) OD); right
knockout is 0.875 in. (22.2 mm) diameter. You remove the inner disk in the combo
knockouts from inside the control box, the outer diameter from outside the control box.
The right knockout is removed from outside the box. To remove a knockout, tap with a
hammer and screwdriver around the circumference of the disk. When removing the inner
disk of a combo knockout, be sure the control box is well-supported.
5.
Connect the black wire to the “L” terminal on TB1, the white (or red) wire to the “N”
terminal, as shown in Figure 2-22 and in Figure 2 at the back of the manual.
Figure 2-22. Shadow 8 AC Wiring Connections
(L)LINE (N)NEUT
Connect green (or green-and-yellow)
wire to set screw terminal
Connect white (or red)
wire to NEUT terminal
Connect black wire
to LINE terminal
Lower left corner
of control enclosure
TB1 PS1
F1