ProCam 1500 SFI Manual
1
Ch 1
1095900
Chapter 1
ProCam 1500 Servo Feed Interface
Your ProCam 1500 Servo Feed Interface is hardware and software that allows you to
operate your servo feed through ProCam 1500. Once installed, you can make all the
necessary settings for your servo feed right at the ProCam 1500 keypad. ProCam 1500
will automatically operate the servo feed during press operation. And because ProCam
1500 is a micro-processor, you can save all your settings for up to 200 tools in ProCam's
electronic memory. You just recall the settings when you use the tool again.
To use the Servo Feed Interface, you must have or install the appropriate firmware chip
into ProCam 1500. Then you simply connect the unit to your servo feed using a cable that
plugs into your servo feed's RS-232 port. See Chapter 2 for installation instructions.
To set your servo feed through ProCam 1500, you simply use the menus on the ProCam
1500 screen. You will see a new selection on the ProCam 1500 programming menu when
you install the interface. The new item is—"SET FEED". When you select "SET FEED"
using the ProCam 1500 keypad, you will see a menu for making SFI settings. You make
the settings using the keypad in the same way that you make all other ProCam 1500
settings. See Chapter 3 for instructions on how to use the menus.
Servo feeds covered in this manual
This manual covers all press servo feeds ProCam 1500 can operate. They include:
• COE
BG2
• COE
CPEC
•
CWP Servo-Dial II
• Dynamic
ServoFeed
•
Indramat CLM-equipped servo feed with either IDS or SOT2 control panels only
•
Reliance CTL (Cut-To-Length)
• Waddington
MiniFeed
