ProCam 1500 SFI Manual
9
Ch 3
1095900
Chapter 3
Using the SFI menus
In this chapter you will learn how to use the SFI menus. You will learn how to use:
• Initialization
mode
•
Setting feed initialization parameters
•
Program mode
•
Setting feed length
•
Setting percent acceleration
•
Setting maximum run speed
•
Using the Feed Advisor
•
Loading feed settings
• Run
mode
•
Adjusting feed parameters while running press
IMPORTANT!
ProCam 1500 SFI works differently with the various models of servo
feeds available.
All SFIs are not alike!
Some do not have
Initialization mode; not all servo feed interfaces have "Feed Advisor,
while others may not allow you to adjust parameters while the press
is running. Programming choices may be different as well.
In this manual, we will present all the possible options available in
SFI, but the available options for your SFI may be different!
Keep this in mind as you proceed!
About Tool numbers
The terms "Tool" or "tool number" will be used many times in this chapter. A tool
number consists of all of the settings (including the servo feed settings) that you make for
one job. You can save servo feed information for up to 200 tools and then recall the
settings for each job whenever you need to.
The Initialization mode
IMPORTANT
This manual mentions certain parameters that you can modify at your
feed. It does not, however, explain these parameters in any detail.
Refer to your servo feed manual for more information.
