V1
14
Winton WAM
6. SAFETY PRECAUTIONS
Always follow these guidelines to ensure maximum safety when operating the machine.
The driver must fully understand the controls and the capacity of the tractor. It is always
recommended the driver practices the controls and the working of the hedge mower in a safe location
BEFORE beginning work. Make sure that the P.T.O speed of the tractor is 540 RPM.
Working on Slopes
When working high with the reach fully in it is possible for the main arm balance to unbalance the
tractor/machine. Always work at the slowest speed possible on slopes and avoid any circumstances
which allow the machine and tractor to become off balance. Tractor wheel weights and front weights
are necessary for all operations.
High Voltage Cables
It cannot be stressed enough the dangers involved when working near high voltage electricity cables.
Before attempting to work in these areas ensure you have read and fully understood the safety section
of this manual. Avoid operating near high voltage cables if possible.
It is advisable that you consult your Local Power Company to obtain information regarding a safe
procedure for working if working near high voltage cables is un-avoidable.
Extra special attention should be applied to Overhead Power Lines. It cannot be stressed enough the
dangers that surround this capability, it is therefore vital that the operator is fully aware of the
maximum height and reach of the machine, and that they are fully conversant with all aspects
regarding the safe minimum distances that apply when working with machines in close proximity to
Power Lines. (Further information on this subject can be obtained from the Health & Safety Executive
or your Local Power Company).
Overhead Obstructions
Always be aware of the height of the machine when working or folded and take care especially when
manoeuvring near or under bridges, buildings, power cables or any other obstacles you may encounter
when moving your machine.
Using Cutting Head Off The Ground
The use of the flail head off the ground or at an angle other than horizontal to the ground can cause
danger to the driver from debris. Always take safety precautions to protect the operator. Guards must
be fitted to the side of the tractor for safety.
Always keep the cutting head as close to the tractor as possible to maintain the greatest stability.
Never direct the cutting head and the flails towards the operator when the machine is in motion .
NEVER CUT ON THE BLIND SIDE OF THE HEDGE. It is impossible to see potential hazards or dangers and
the position of the flail head could allow debris to be propelled through the hedge towards the tractor
and the operator.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR ANY ACCIDENT CAUSED BY NON-
OBSERVANCE OF THE INSTRUCTION MANUAL.
