V1
8
Winton WAM
2. INSTALLATION & SET UP (continued)
Safety: Ensure tractor and machine is stopped & keys out of ignition before set-up/maintenance.
Safety: Before attaching/detaching machinery ensure the hydraulic lift system is in a neutral position.
Safety: Make sure the PTO drive isn’t connected at any point until instructed to do so.
Detaching From The Tractor
On a flat area of ground with good access, lower the three point linkage on your tractor in line with the
machine linkage and then follow these steps:
1.
Close the angle of the cutting head using the hydraulic lever.
2.
Then use the lever to bring the cutting arm back towards the machine.
3.
Lower and secure the stabiliser legs E to the machine using the pins.
4.
Lower machine to the floor and ensure it is stable, if not then stabilise the unit.
5.
Turn off the tractor and ensure PTO drive shaft is stopped.
6.
Remove the chains from the PTO and remove the PTO shaft from tractor & machine.
7.
Disconnect the top link A and bottom link arms.
8.
Remove the hedge cutter controls from their mount on the tractor.
9.
Start the tractor and slowly drive off from the position, checking all connections are free.
E
