37. Features Programming Table (2)
Follow the steps as below.
(1)
Turn the ignition ‘Off”
(2)
【
Total 3 times press of override switch for valet mode
】
【
Total 4 times press of override for programmed daily start-time
】
【
Total 5 times press on override for temp-controlled auto start.
】
※
Number of presses on override switch is followed by equal siren chirps.
(3)
Turn the ignition “ON” to decide in each features mode.
(4)
Press again override switch once /twice to decide each feature “ON” or “OFF”
※
The shaded indication like OFF is the factory default modes.
Features Program Table (2)
Once
Twice
3 times, valet
ON
OFF
4 times, programmed daily start time on/off
ON {Refer below note}
OFF
5 times, time-controlled auto start on/off
ON
OFF
Siren and L E D indicator
1
2
Note: NOTE: Having set the programmed daily start time mode “ON”, when the ignition is turned “OFF” , the engine will
immediately be running to indicate this feature in at standby mode. (Use remote control to engine stop engine running in this
case.)
38. How to restore setting to factory default.
Follow the steps as below.
(5)
Turn the ignition “ON” (Engine must not be running)
(6)
Press and release the override switch 10 times.
(7)
Turn the ignition “ OFF” (Siren chirps 10 sounds. This confirms system has entered features
programming mode.)
(8)
Press over-ride switch.1 more time. Siren chirps 1 time to confirm the # 30, #31 are ready for change
of default
(9)
Press remote’s button
【
】
Its buzzer makes 1 sound to confirm # 30, # 31 are restored to factory
default.
39.
Manual ARM / DISARM Modes
【
in case that the remote transmitter is lost)
】
Manual Arming
(a)
Turn the ignition “ON” (The engine must not be running)
(b)
Press and release the over-ride switch 8 times.
(c)
Turn the ignition “OFF” (siren chirps 1 time with 1 parking light flash), the system enter ARM mode
20 sec afterwards. [During Manual Arm mode; if there is any incidence to security, siren chrips3 times
With 3 parking light flashes); 20 sec afterwards, the system enter Alarm mode & Warn Away [Refer to
# 16]
Manual Disarming
(a) Turn the ignition “ON” (The engine must not be running)
(b)
Press and release the over-ride switch 4 times.
Over ride
Features programming
