Wintal DVDR-X40, Руководство пользователя

Страница: 14 / 40

14
CONNECTIONS
1
2
3
S-Video Connection
This is a higher quality connection than standard composite video, and requires an S-Video cable (not included). The
S-Video connector is distinguishable by its 4 pins, as shown below. If your TV has an S-Video input jack, it's
recommended that you use this type of connection for better picture quality.
Turn on the unit and select DVD mode.
Component Video Connection
The highest quality video connection, component video separate cables for the Y , / /
Pr (red) video signals. To use the progressive scan option on this unit, you must use the component video output and
connect to the YPbPr input on your television. Connect the component video output requires these steps:
uses (green) Cb Pb (blue) and Cr
1
First, use a component video cable to connect to the
component video input on your TV from the device.
Resetting the video output
If you inadvertently switch the OUTPUT FORMAT setting to
PROGRESSIVE while using a standard TV not capable of
PSCAN, you will lose video. If this happens, reset the
recorder to its default video settings by pressing PSCAN,
then SELECT on the remote control.
S-Video
Input Jack
S-Video Cable
1
Component Video
Input Jacks
Y
Cb Pb / Cr Pr /
Component
Video Cable
Connect an S-Video lead to the S-Video output on
the unit to the corresponding input on your TV.
Connect the audio output of the unit to the
corresponding audio input of the television.
On your TV, select the S-Video input. This is
normally done by selecting S-VIDEO with the
remote control. On some TV S this is done by
selecting a particular channel.
To change the TV OUT MODE to the progressive
scan, press the PSCAN, then SELECT key. Make
sure the TV is set to the correct video input.
TV with
Component
Video Input /
Progressive Scan
cap ability
VIDEO
INPUT
L R
Y Pb Pr
L
R
TV with
S-Video Input
S
For more information, pls consult your
television manual.
Note: The S-Video input port on your television
may be called SVHS, AV2 or S-Video in, etc..
Ensure that you connect the audio leads into the
same input group. Eg: SVHS Audio In L/R
2
2
Turn on the unit and select DVD mode.
3
On your television, select the YCbCr or YPbPr input,
according to the input you used. For more
information, consult your TV manual.
Progressive scan mode
Progressive scan outputs a higher resolution image to
compatible televisions, giving you higher picture quality. To
enable this, complete the following step.