Winget 2B1500, Руководство оператора и каталог запасных частей, Страница: 34 / 170

Safe handling of batteries
The battery contains a
sulphuric acid electrolyte
which can cause severe
burns and produce
explosive gases.
Wear protective clothing,
gloves and goggles when
servicing the battery.
Avoid contact with the skin,
eyes or clothing. If spilled
onto the skin, flush
immediately with cold water.
If splashed into the eyes,
flush immediately with cold
water for 15 minutes and
get prompt medical
attention.
Do not take internally. If
accidentally swallowed, call
a doctor immediately.
Do not use a naked flame or
smoke near the battery. Do
not produce sparks with
cable clamps when charging
the battery or starting the
engine with a slave battery.
Always disconnect battery
leads, or activate battery
isolator where fitted, before
carrying out any
maintenance to the electrical
system.
ALWAYS dispose of
unserviceable batteries
safely. Comply with local
byelaws and national
regulations on the disposal
of hazardous waste. Consult
your local authority for
addresses of local
designated disposal points.
Every 50 hours
Check battery electrolyte level
The battery is situated beneath a cover
on the left-hand side of the dumper.
Ensure that the electrical connections
are clean and tight, and coat the
terminals with petroleum jolly to protect
them from corrosion.
Remove battery filler plugs and chock
that the electrolyte level is between 6 -
9 mm (0.25 - 0.37 in) above the tops of the
separators.
If necessary, top-up with distilled water.
Replace battery filler plugs and tighten
securely.
Battery removal
if the battery is to be
removed from the machine,
ensure the following
procedure is used.
Switch the engine off.
Remove the starter key from the machine.
Ensure all electrical circuits are
switched off. Activate the battery
isolator, where fitted.
Remove the battery cover and clamp.
Disconnect the earth (-) load from the
battery before removing the positive (+)
load.
Lift the battery from the machine.
When installing the battery,
the positive
(+) lead MUST be
connected first.
SERVICE 3.11
BATTERY