Winget 2B1500, Руководство оператора и каталог запасных частей, Страница: 28 / 170

Every 250 hours
Oil filter
Change oil filter element as follows:
Using a suitable strap wrench,
unscrew and remove the old filter
(A).
Do not attempt to clean the old
filter! Dispose of it safely.
Thoroughly clean the crankcase filter
housing face.
Apply a small amount of clean
engine oil to the filter sealing joint.
Do not use a strap wrench to fit
the new element.
Screw on the new filter by hand,
until the sealing joint is just
touching the crankcase and then
tighten a further half turn.
Drain and refill the oil sump
Change the sump oil as follows:
If possible run the engine
immediately before draining the oil.
Place a suitable container under the
drain plug. Remove the drain plug
(D) and drain oil.
Clean and coat the threads of the
drain plug with an appropriate
sealant.
Replace the drain plug
(D) taking
care not to over tighten it.
Fill the sump through the oil filler
(C)
to the top mark on the dipstick (B).
Start the engine, run it for a few
minutes and check the drain plug,
and the oil filter do not leak.
Stop the engine, allow the oil to
settle for 2 minutes. then check the
level on the dipstick
(B).
Add more oil if necessary.
For correct grade of engine oil, see
"Specifications".
ENGINE
3.5 SERVICE