Winget 200TM, Руководство по ремонту

Страница: 82 / 149

200TM DRUM ASSEMBLY
CAREFULLY REMOVE THE RUBBER
SEALS FROM THE DRUM BEARINGS,
PACK WITH GREASE THEN REFIT SEALS.
I NSTALL THE DRUM SHAFT AND BEVEL GEAR INTO
DRUM BASE AND FINGER TIGHTEN THE RETAINING
SCREWS, ITEM 17.
CHECK THE GAP BETWEEN THE EDGE OF THE
BEVEL THE GEAR AND DRUM (DUE TO
MANUFACTURING TOLERANCES). INSTALL SHIMS
ITEM 15A OF VARYING THICKNESS AS NECESSARY
EQUISPACED AROUND THE CIRCUMFERENCE
OF THE BEVEL GEAR IN 6/8 POSITIONS.
THIS WILL ENSURE THAT WHEN THE RETAINING
SCREWS ARE TIGHTENED THE CAST
BEVEL GEAR WILL NOT BE DISTORTED.
SEAL ROUND THE GEAR/DRUM
CIRCUMFERENCE USING A SUITABLE
FLEXIBLE SEALER
COAT THE TEETH OF THE
BEVEL GEAR WITH A GOOD
QUALITY OPEN GEAR FLUID
BEFORE ASSEMBLING THE
DRUM INTO THE TRUNNION.
COAT THE DRUM SHAFT AND BORES
OF THE TRUNNION WITH ANTI SIEZE
COMPOUND (COPPER GREASE)
BEFORE ASSEMBLING INTO THE
TRUNNION