Winget 200TM, Руководство по ремонту

Страница: 7 / 149

WORKSHOP MANUAL
Winget Mechanically Fed Mixers
Models: 200TM
From 1998
Lifting Points
Lifting points capable of supporting the weight of the mixer are incorporated in both
the rear leg of the mainframe and on the upper leading edge of the hopper cradle.
The lifting points are highlighted with an ISO ‘Hook’ symbol adjacent to each point.
On Military/Nato mixers the lifting points are also painted white.
The hopper also incorporates lifting points to assist in removing the hopper. The
hopper lifting points are not highlighted to avoid confusion with the main lifting points.
On no account must the hopper lifting points be used to support the weight of the
mixer.
Pneumatic/Steel Wheel Replacement.
The pneumatic or steel wheels are secured to the axle stub shafts using a collar
retained via a long bolt and binx nut. To replace a wheel jack up and support the axle
adjacent to the stub shaft, undo and remove the retaining bolt slide off the collar
followed by the wheel. Pneumatic wheels are fitted with a removable needle bearing,
which can be grease via the grease point. Reverse the procedure to replace a wheel
not forgetting to lubricate the stub shaft and needle bearings with grease prior to
assembly.
Axles Front & Rear.
Using suitable lifting equipment lift and support the mainframe. The Rear axle is
retained to the mainframe using four bolts, flat washers and binx nuts. Remove the
bolts and carefully manoeuvre the axle clear off the frame. Reverse the procedure to
refit.
The front axle is retained via a pivot pin, washers and split pins, to remove lift and
support the mainframe using suitable lifting equipment. Straighten the split pins and
remove from the pivot pin. Using a suitable drift and hammer knock the pivot pin up
through the axle and manoeuvre the axle clear. Reverse the procedure to refit not
forgetting to coat the pivot pin with anti-seize compound and fit new split pins. The
axle is prevented from rotating to far by the use of two M10 set screws as axle stops
if the axle is changed do not forget to replace the stop screws.
Lower the mainframe and allow to stand on the wheels, if pneumatic wheels are fitted
check and adjust the tyre pressures.